Hit-products LogicPLUS S 42/128 Manual de usuario descargar pdf (Pagina 28)

LogicPLUS-S Two-Wire Controller



Hit Products has developed a user friendly, exible means to identify the number of the eld pro-

grammed receivers during the receiver programming process. Inside every box of programmable

receivers, you will nd one set of identication tags numbered 1-128. You will use these receiver

identication tags as follows:

1. Every time a receiver is programmed, nd the corresponding numbered identication tag and

immediately attach to receiver.

2. To attach identication tag to receiver, insert one red receiver wire into the hole (from front to back)

to the left of the appropriate numbered tag as you are looking at the number. Pull red wire all the

way through the hole until identication tag is approximately one inch from body of receiver.



3. Insert same end of same red wire back through hole (from back of tag towards front) and continue

to pull wire through until tight. The number on the tag should now be readily visible and the red

wire positioned on back (blank side of tag). See above.

4. Should receiver ever be reprogrammed to a different number, make sure to replace the

identication tag with the appropriately numbered identication tag. Failure to do so can

create extreme confusion!

RED

BLACK

LED

RECEIV-

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 44 45

Sin comentarios

Hit-products LogicPLUS S 42/128 Manual de usuario Pagina 28