Hit-products LogicPLUS S 42/128 Manual de usuario descargar pdf (Pagina 20)

LogicPLUS-S Two-Wire Controller











Program the amount of loop time in position 7. When the remote sensor activates and closes

the contacts for more than 30 seconds, program 6 will operate for the looping time programmed.

If for any reason the remote sensor contact opens during the looping cycle, the looping cycle will

continue until the programmed time is completed. The sensor must open and close the contacts

to operate the looping cycle a second time. If, for any reason, the contacts open and close dur-

ing the pre-programmed length of looping, the looping program will reset at that time and start

over again.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 44 45

Sin comentarios

Hit-products LogicPLUS S 42/128 Manual de usuario Pagina 20